1-805-484-2992

Quotes - Sizing - Sales

R-22 & Refrigerant Phase-Out Guide

What an Older Refrigerant Means for Your Timeline

Overview

R-22 production and import have ended in the United States - a working R-22 chiller isn't illegal to run, but the refrigerant behind it only gets scarcer and more expensive from here.

R-22 refrigerant production and import for use in the United States ended under the EPA's phase-out schedule, which means the only remaining supply is recycled, reclaimed, or existing stockpiled refrigerant - a shrinking and increasingly expensive pool. A chiller running on R-22 isn't required to be replaced simply because it exists, but a refrigerant leak or a repair requiring a significant recharge can turn into a costly, hard-to-source event on short notice.

This matters for chiller replacement planning in a specific way: the risk on an R-22 unit isn't steady, predictable wear-and-tear cost, it's the chance of a sudden, expensive refrigerant event that a newer unit running a current refrigerant simply doesn't carry. That risk profile is worth weighing separately from - and often more heavily than - the unit's general mechanical condition.

If your current chiller runs R-22, that's worth factoring into a replacement decision even if the unit is otherwise running fine, since the phase-out timeline isn't something a repair can fix. A newer unit also typically delivers better efficiency on a current refrigerant, which is a real ongoing cost difference on top of the phase-out risk itself.

  • R-22 production and import for U.S. use has ended - remaining supply is recycled/reclaimed only
  • The real risk is a sudden, expensive refrigerant event, not steady predictable repair cost
  • Worth factoring into a replacement decision even on an otherwise mechanically sound unit

Plan an R-22 exit around risk, not a hard deadline.

Running an existing R-22 chiller is still legal, but only reclaimed refrigerant is left and recharge costs keep rising. Schedule the replacement for a planned shutdown or slow period, before a failure picks the date.

Planning Your Timeline

An R-22 unit doesn't need a replacement plan built around a hard deadline the way some regulated equipment does - it needs one built around risk tolerance. A process that can absorb a multi-week parts-and-refrigerant delay if something fails can reasonably run an R-22 unit longer; a production line that stops the moment cooling does usually can't.

The practical move for most sites is scheduling replacement on your terms, during a planned shutdown or slow period, rather than reacting to a failure that forces the decision at the worst possible time and price.

Worth Checking Now

  • Confirm the refrigerant type on the nameplate or with your service contractor
  • Ask what a full recharge would currently cost, if you don't already know
  • Identify whether your process can tolerate an unplanned outage
  • Consider scheduling replacement during a planned shutdown, not a failure

R-22 vs. A CURRENT REFRIGERANT

Factor R-22 (Legacy) Current Refrigerant
U.S. production/import Ended - reclaimed supply only Ongoing, widely stocked
Repair/recharge cost Rising, increasingly volatile Stable, predictable
Failure risk profile Sudden, high-cost events possible Routine, plannable service
Typical efficiency Lower than current-generation equipment Improved on a modern compressor platform

These are general trends, not a quote - your specific unit's condition and duty still drive the actual comparison.
Call and talk it through with an engineer: 1-805-484-2992.

R-22 Chillers: Questions Owners Ask

Often it can, but treat a conversion as a major repair, not a way around the replacement decision. The work keeps the old compressor, coils and controls, so the unit's age and wear stay exactly where they were. Ask the contractor what capacity and efficiency the unit is expected to deliver on the new refrigerant, whether oil and seals must change, and what the job costs. Then set that figure beside a replacement quote, the way any large repair is weighed. A conversion makes most sense on a unit in good mechanical shape with plenty of service life left.

Repair it if the unit is sound and the leak is found and fixed, but use the event to start planning, because the next one may not be small. A leak is the case R-22 owners plan around: recharge refrigerant now comes only from a recycled, reclaimed or stockpiled pool, and its price is rising and volatile. Get the recharge cost in writing, ask whether the leak point is a one-off or part of a pattern such as corroded tubing, and log how much was added. A second leak within a short span is a strong signal to book the replacement for the next planned shutdown.

Often it does, because reclaimed R-22 has a market as supply keeps shrinking, so the charge in the old unit should not be written off as waste. Raise reclaim credit with the certified technician who will recover it, before the changeover is scheduled, and ask how the charge will be weighed and credited. The recovery itself is required whoever supplies the new chiller, so book it as it's own step.

No. On a packaged chiller the refrigerant stays inside the unit, and the glycol loop, pumps and process piping form a separate circuit that does not care which refrigerant the chiller uses. The connections still have to suit the new unit, and the fluid should be tested before it goes back in. The exception is a split system with field-run refrigerant lines to a remote condenser: those lines were sized and cleaned for the old refrigerant and oil, so have them evaluated before anyone assumes they can stay. Tell us which type you have when you request the quote, since a split system changes both the scope and the schedule of the swap.

Quote Request Form:

Questions?

1-805-484-2992

Quotes - Sizing - Sales